Have a Ford 302 engine with a 600 Holly Carb and elderbrock intake manifold. It is mated to a C-6 transmission. It is still in the truck,a Ford 1981 F-100 Ranger. It has headers that are two into one into two with chrome tip exhaust pipes. Pictures available. The truck has the following:
QR Code Link to This Post
New heater core.
New Water pump
New fuel pump
New fitted upper and lower radiator hoses(new coolant).
New distributor cap
New rotor button
New plug Wires
New spark plugs
New Ranchero shocks ,front and rear
New front calipers, right and left.
New right and left rotors
New right and left inner and outer front wheel bearings
New right and left brake pads
New brake lines
New master cylinder
New outer tie rod ends,left and right. ( Will need a front end alignment)
New engine oil and filter
New transmission filter and fluid
New transmission tail shaft. support bracket(rubber)
New universal joints front and rear on drive shaft
New rear brake drums. Right and left
New rear brake pads. Right and left
New rear wheel cylinders. Right and left
New rear brake actuator components. Right and left
New wiper blades. (uninstalled in packaging)
New direct reading pressure gauge in cluster for temp and volt meter gauges.
New dope in rear end
Tinted glass, doors and back glass
Like new tires(25 miles) mounted on P C W deep dish chrome wheels with wheel locks.
Has side gas tank that will need to be cleaned. It has been removed from truck. I purchased a new rear fuel tank with fuel pick up and straps with the intention of installing it in the truck bed.
Driver side side mirror is broken
Horn is in op
Tack is in op
passenger side door does not lock
Does not have rear tail gate